En/Microclient JR DXのソースを表示

[[画像:MCJRDX-1.jpg|320 px]]<br>
==Specifications==
CPU : Xcore86 DX 1GHz(Vortex A9120 933MHz) -> http://www.vortex86dx.com/<br>
Memory : 256MB (512MB version will available at 2009Q2)<br>
VGA : XGI Volari Z9s http://www.xgitech.com/products/products_2.asp?P=23<br>
ROM : AMI BIOS<br>
Storage: Compact Flash X 1,microSD X 1<br>
HDD : 2.5" PATA X1 can be installed.<br>
LAN : 100Mbps Fast Ethernet(PXE boot,WOL) RDC R6040<br>
Dimensions: 115x115x35mm 505g(without HDD)<br>
Price: Start from $140(Single unit.Without S&H. Available from [http://www.norhtec.com/products/mcjrdx/index.html NORHTEC])<br>

==Description==
[[画像:MCJRDX-2.jpg|320 px]]<br>
microSD on front side. Bottom of CF slot.<br>
Marked as "SD" but "microSD".<br>
<br>
[[画像:MCJRDX-3.jpg|320 px]]<br>
Rear view. This unit without RS232C<br>
<br>
[[画像:MCJRDX-4.jpg|320 px]]<br>
Inside Top view.<br>
==Storage Configuration==
Single microSD,CF slots on Front side.You can use micro SD and CF same time.<br>
2.5" HDD can be installed inside.(But mini PCI model,You can't install HDD.)<br>
*Default Configuration.
:microSD : IDE Primary Master.<br>
:CF/2.5HDD : IDE Secondary Master.<br>
*Swith CF Priority
:There is a "Slide Switch" located inside of CF Slot.
:[[画像:MCJRDX_SS1.jpg|240 px]]
:Change this switch to "Slave",CF Slot will work as IDE Secondary Slave.
:[[画像:MCJRDX_SS2.jpg|240 px]]
:This switch can be access from CF Slot.
:To Change HDD priority, You must use "Jumper" setting on HDD itself.
*To select boot device, Press [F11] at power on screen.
:or use BIOS setup menu to change boot priority.